Page 1 of 1
campag centaur bottom bracket tool?
Posted: Fri Jun 05, 2009 12:56 pm
by Dom S Teak
Hi'
Has anyone local to York got a bottom bracket tool to fit a Campag Centaur (square taper E/thread) BB cup?
I wouldn't need to borrow it, I can just whip my frame 'round in the car and tighten up.
Cheers.
Dom
Posted: Fri Jun 05, 2009 1:33 pm
by AndrewM
Is it the ultra drive (ie the new one with no bottom bracket)
If so, I have the very tool, and the one to tighten/release the cups as well.
centaur bb tool
Posted: Fri Jun 05, 2009 1:55 pm
by Dom S Teak
Just my luck, i'm afraid mine is the standard set up with cartridge BB not the U/T splined axel.
Thanks anyway.
Posted: Fri Jun 05, 2009 5:29 pm
by alistairs
I've got the standard BB tool for campag. The splined one that fits over the square end of the bottom bracket to tighted the cup into the frame.
Its not the one for the bottom bracket with about 6 semi-circles round the edge of the bottom bracket.
I'm in Knapton so pretty close. 07770 781534 if you want to call me.
Al
Posted: Fri Jun 05, 2009 5:39 pm
by alistairs
For the avoidance of doubt... and as my description was utterly pants... this one:
http://www.wiggle.co.uk/p/cycle/7/LifeL ... 360031520/
centaur bottom bracket tool
Posted: Fri Jun 05, 2009 7:48 pm
by Dom S Teak
Thanks Alistair, .. worked a treat!